Post by williamhawk on Sept 21, 2017 23:22:25 GMT -5
I have a sequence (ProjectA) that has been built to be controlled manually (i.e. Wait for a keypress is ticked) and which is set to close after the last slide. When I Preview this sequence, or Publish the EXE and play the EXE, the sequence behaves as though the control option for closure is "Loop until Esc is pressed". I have tried to re-create this situation in a test sequence (ProjectB) and have failed. If I Publish a new EXE file (ProjectA2) from the ProjectA project file, it also behaves as though "Loop until Esc" had been selected. Soemthing isn't right here but I cannot get a repeatable creation of the fault in a controlled environment.
I didn't find the right solution from the Internet.